Why do earthquakes break water lines inside houses?
Lines are rigid in places and flexible in others, and they are fixed to a structure that moves. When the house shifts, the rigid sections can crack and the joints can separate.
Supply pipes run through walls, under floors and across the foundation, and each run is fixed to the framing at intervals. During shaking, the framing moves at a different rate from the pipe, and the pipe is pulled and pushed. A joint that was tight can open, and a section that was clamped to a stud can crack where it meets the clamp.
A shifted foundation makes things worse. If the house moves off its footings, the point where the service line enters can be pulled sideways, and the connection can separate at the wall. Those breaks are often hidden until water begins to appear in the room below.
Why is an earthquake break hard to find after the shaking?
Damage can be concealed in walls and under floors, and it may not produce water right away. A break can drip slowly for days before it becomes a stain, and it can move as the house settles.
After a quake, a homeowner may see nothing wrong on the surface. A wall may look intact while a cracked line inside it slowly weeps into the cavity. The water travels along the framing, so the first visible sign can be a stain several feet from the break.
Crews use moisture readings and a look at the connections to narrow the search. They check the service entry, the water heater connections and any appliance hookups, and they follow the damp pattern before opening a wall. That approach limits how much of the house has to be opened to find the break.
How does a homeowner work with the gas utility after a quake?
Gas and water are separate systems with separate shutoffs, and the gas utility is the authority for any gas problem. A homeowner should not restore gas on their own, and should follow the utility's instructions after a shake.
If there is any sign of a gas leak, leave the house and call the gas utility and emergency services from outside. Do not light a match or switch electrical equipment on or off near a suspected leak. Water work can wait until the gas risk has been cleared, so that a plumber or a crew is not working near an open gas line.
A gas shutoff at the meter is operated under the utility's procedures, and a homeowner should ask the utility about its process rather than guess. The crew's record notes whether the gas connection appeared intact so the homeowner can pass that information along when the utility visits.
What should be done in the weeks after a quake?
A house that shifted should be checked by a licensed contractor or engineer for the foundation, and every water connection should be tested before the walls are closed. Drying and repair are the first steps; structural work follows.
Water that was dried quickly is not the same as a connection that has been tested. Plumbers pressure-test repaired lines, and the crew's readings show whether the structure has held dry. Walls that were opened during the response should be inspected before they are closed, because a line that was disturbed may be leaking at a joint nobody saw.
The foundation is a structural question for a licensed professional. The Contractors State License Board lookup at cslb.ca.gov lets a homeowner check a contractor's license before hiring, and the homeowner should ask any contractor for references on earthquake repairs.