Creek and Culvert Flooding
Water backing up from a buried creek or a blocked culvert is pumped out, the silt it leaves is removed and the structure is dried.
Berkeley water damage falls into a few families: storm and creek water, leaks from older plumbing, sewer backups, earthquake breaks and the drying and cleanup that follow any of them. Each service page describes one source, and the walkthrough confirms which one applies.
Fastest: call (833) 490-5225. Or send this and we call you back.
Start with the source of the water, since that decides the first step. Storm water from a November or January rain is handled differently from a leak under a sink or a backup from a drain, and each service page sets out its own first steps.
Every service follows the same sequence: stop the water, remove what cannot be dried, dry to readings, then record. The pages below show how each source is read and what the written scope usually includes.
Water backing up from a buried creek or a blocked culvert is pumped out, the silt it leaves is removed and the structure is dried.
Heavy winter rain that soaks a house from roof to foundation is pumped out, dried to readings and checked again on a return visit.
Rain that runs fast down a slope into a lower room is diverted, the water is extracted and the structure is dried to readings.
Water that collects in a crawlspace is pumped, the damp soil and debris are cleared and the joists and subfloor are dried.
Corroded galvanized supply pipe that weeps or fails is isolated, the water is removed and the wall and floor are dried and checked.
A leaking cast iron drain inside a wall or floor is located, the wet materials are removed and the cavity is dried for the plumber.
The flow from a burst supply line is stopped, the standing water is pumped out and the wall, floor and framing are dried to readings.
Sewage that has backed up into a building is removed as contaminated waste, surfaces are sanitized and the room is dried to readings.
Water lines broken by shaking are isolated, the water is removed and the structure is dried while the connections are inspected.
A leaking water heater is shut down and drained, the water is removed from the floor and the wall base is dried and checked.
A leaking washer, dishwasher or refrigerator is isolated, the water is removed from the floor and the subfloor and cabinets are dried.
A leak in one unit is stopped, the water is removed and the shared ceilings, walls and floors of affected units below are dried and recorded.
A wet ceiling or wall board is opened at its low point, the water is removed and the cavity and framing are dried before the finish is replaced.
Water that enters through the roof is stopped where it is still coming in, the attic and ceilings are dried and the leak point is recorded for the roofer.
Air movers and dehumidifiers are set to dry framing, subfloors and cavities, and drying ends only when the readings reach their targets.
Mold that grows after a water event is located behind finishes, affected material is removed and the area is dried and rechecked.
Standing floodwater is pumped out of the building before drying starts, with silt removed while it is soft and the water logged for the record.
A flooded basement or garage is pumped, its silt and soaked materials are removed and its slab and wall base are dried to readings.
| Service | Typical range | Details |
|---|
Estimates only. Your price is confirmed on site before work starts. See the full price guide.
If it's an emergency, call now. For non-urgent service, send the form and we'll call you back.
Choose by the source of the water, not by the room it is in. A caller describes where the water came from, and the service that fits is the one that matches that source. If you cannot tell, say so when you call.
Mold follow-up is part of the drying and cleaning sequence. Growth found during drying is documented first, and the mold service page describes how it is handled.
Yes. A storm can bring water into a ground floor from the yard and back up a drain at the same time. Each source is recorded and handled with its own steps, and the written scope shows which steps belong to which source.
Because water from a buried creek can still reach a house through the ground, a foundation or a drain. The creek service page explains what the source looks like and how it is read.