Why does a crawlspace collect water when the house is sound?
Water moves toward the lowest open space it can find. A crawlspace is often the lowest enclosed area of the house, so it takes water from the soil and from any leak in the structure above it.
The ground under a house holds moisture, and that moisture moves with the seasons and with rain. A crawlspace with bare soil or a torn vapor barrier lets that moisture rise into the air and into the wood. Even without a storm, a damp crawlspace can stay damp for long periods because the air inside it does not move freely.
A storm changes the picture. Water that runs off the roof, sheets along a sloped yard or sits against the foundation can enter through a vent, a cracked stem wall or the gap at the sill plate. Once it reaches the soil, it spreads under the whole floor and stays there until it is pumped out and the ground is dried.
What damage does standing water do to the floor above?
Water in the crawlspace wets the joists and subfloor from below, which is the part of the floor the homeowner cannot see. The wood swells, loses strength and, if the water stays, begins to rot.
Wood that stays wet for days can take on enough moisture to swell and warp. The subfloor is the first layer to fail, and it may look fine on top while the underside is soft. The floor above can then feel bouncy or uneven, and the screws or nails that hold the boards loosen as the wood moves.
Mold and rot follow when the wood does not dry. Crews measure the joists at several points to find the wet zones, and they check the sill plate where it rests on the foundation. Any wood that has lost strength is reported, so the repair can be scoped by a builder.
How is a crawlspace dried when access is tight?
Drying a crawlspace relies on airflow through a few openings, careful placement of equipment and readings taken in every bay. Access is limited, so the plan is built around the vents and the access door that already exist.
Equipment is set in the space through the access door or a temporary opening cut where it will not weaken the foundation. Air movers direct air across the joists and the soil, and dehumidifiers pull moisture out of the air that is trapped below the floor. Fans are moved between bays so every section is covered.
Drying is measured rather than guessed. Readings are taken on the joists, the subfloor and the soil at several spots, and the work continues until each one reaches its target. A crawlspace that dries on one side and stays wet on the other is not finished, and the crew says so in the record.